![vcm 2 not recognized vcm 2 not recognized](http://blog.eobdii.fr/wp-content/uploads/2018/01/vcm-problem-3.jpg)
The yellow status is where most connection failures tend to occur, and there are several options to get more information on this:Ī) Tapping on the OBD status bar will show its current status (unless you are currently recording), and may include troubleshooting tips, depending on the situation.ī) Going to the "Data Channels & Codes" screen will show its live status as it attempts to connect. This will initially be flashing red but will become yellow upon attempting an MPVI2 and vehicle connection.
![vcm 2 not recognized vcm 2 not recognized](http://blog.obdii365.com/wp-content/uploads/2020/03/vcm-ii-firmware-upgrade-downgrade-01.jpg)
Once you have the MPVI2 paired to your device and TrackAddict is set to use it, you should see an OBD status bar at the bottom of the main Setup screen and some others. Unfortunately, iOS is not currently supported due to Bluetooth restrictions on that platform, but we are working on options to support iOS in the future.
#Vcm 2 not recognized android#
If it is showing up as "WT12A" or similar, it won't be recognized for TrackAddict and it will need a firmware update.ĥ) You should be using the Android version of TrackAddict. If it doesn't, tap on "Setup HP Tuners MPVI2" and follow those steps for the pairing and setup process.Ĥ) Your MPVI2's Bluetooth name should be "HP Tuners MPVI2". The "OBD" selection should be set to "Bluetooth" and the button below it should say "OBD Device: HP Tuners MPVI2". It may work if the ignition is on, without the engine running, but please note that some vehicles will power down after a couple of minutes without the engine running.ģ) Open TrackAddict to its main Setup screen (wrench/gear icon on left of navigation bar), then tap on the 'i' gear icon on the left side to go to the Options screen.
#Vcm 2 not recognized update#
This may apply a firmware update, and you should resync it once again if any firmware update is applied.Ģ) The MPVI2 should be plugged into the vehicle and its engine should be running. (2960) : VCM Firmware Version: 4.1) The MPVI2 will need to have first been activated by connecting it to your computer via its USB cable and syncing it via VCM Editor or VCM Scanner (Help -> Resync Interface). (2960) : Onboard Administrator Role: Active (2960) : Target name: BladeSystem c3000 Enclosure (x86)\Hewlett-Packard Company\Virtual Connect Support Utility\vcsu-11500.log VCSU log file is available at the following location: C:\Program Files ERROR: One or more parameters are not valid Copyright (C) 2006-2012 Hewlett-Packard Development Company, L.P. HP BladeSystem c-Class Virtual Connect Support Utility Error in getting the FirmwareIncompatible Statusīelow is the text from the log-file, but I cannot find anything that reveals my error.
![vcm 2 not recognized vcm 2 not recognized](http://blog.eobdtool.co.uk/wp-content/uploads/2019/09/ford-vcm-ii-update-via-obd-7.jpg)
ERROR: One or more parameters are not valid Vcsu -a update -i 172.17.1.21 -u Administrator -p xxxxxxx -l C:\vcfwall485.bin -vcu Administrator -vcp xxxxx However, I'm receiving an error when I issue this command:
#Vcm 2 not recognized upgrade#
Has anyone successfully completed this upgrade? I'm trying to upgrade a " HP VC FlexFabric 10Gb/24-Port Module" - which apepars in the supported list in the release-notes.